Manhart How to operate the hydraulic servo CNC bending machine safely?

**Guide to safe operation of hydraulic servo CNC bending machine**
I. Introduction to the equipment and application fields
The hydraulic servo CNC bending machine is a high-precision and high-efficiency sheet metal processing equipment that achieves precise bending of sheets through advanced servo systems and hydraulic drives. The equipment is widely used in sheet metal processing in the fields of home appliances, automobiles, construction, ships, aerospace, etc., to meet the bending needs of various complex shapes.
II. Safety operating procedures and precautions
1. Operators must receive professional training and be familiar with the equipment operating procedures and safety precautions.
2. Wear protective clothing and protective equipment that comply with safety regulations during operation, such as safety helmets, gloves, protective glasses, etc.
3. Cleaning, maintenance or other non-operational behaviors are prohibited while the equipment is running.
4. Ensure that there are no obstacles around the equipment to prevent collision accidents.
5. Regularly check the safety devices of the equipment to ensure that they are in good working condition.
III. How to correctly open and close the equipment
1. Before opening the equipment, check whether the power supply, air pressure, hydraulic pressure, etc. are normal.
2. Press the equipment start button to start the control system and perform a self-check on the equipment.
3. Check whether all parts of the equipment are operating normally. If there is any abnormality, stop the machine immediately for inspection.
4. After processing, press the equipment stop button, turn off the control system, and cut off the power supply.
IV. Bending process and mold selection principles
1. Select a suitable mold according to the properties of the sheet and the bending requirements.
2. Set reasonable parameters such as bending angle, speed and pressure to ensure the bending quality.
3. Pay attention to the installation position and angle of the mold to avoid sheet offset or deformation.
4. Check the wear of the mold regularly and replace or repair it in time.
V. Common fault troubleshooting and treatment measures
1. The equipment cannot be started: check whether the power supply, air pressure, hydraulic pressure, etc. are normal, and restart after troubleshooting.
2. Low bending accuracy: Check whether the mold matches and whether the parameter settings are reasonable. If necessary, adjust the mold or replace it.
3. Sheet offset or deformation: Check whether the mold installation position and angle are correct, and adjust the sheet positioning device.
4. Hydraulic system failure: Check whether the hydraulic pipeline is leaking, whether the oil pump is damaged, etc., and repair or replace it in time.
VI. Parameter setting and optimization suggestions
1. According to the properties of the plate and the bending requirements, reasonably set the bending angle, speed and pressure and other parameters.
2. For bending parts of special shapes, segmented bending or pre-bending can be used for optimization.
3. Regularly calibrate and optimize the equipment parameters to ensure that the equipment is in the best working condition.
VII. Maintenance methods and cycle recommendations
1. Clean and lubricate the equipment regularly to keep the equipment clean and tidy.
2. Regularly check whether the fasteners, transmission parts, etc. of the equipment are loose or worn, and tighten or replace them in time.
3. Regularly replace wearing parts such as hydraulic oil and filters to ensure the normal operation of the hydraulic system.
4. It is recommended to conduct a comprehensive inspection and maintenance of the equipment every six months.
VIII. Technical support and after-sales service
We provide professional technical support and after-sales service, including equipment installation, commissioning, training, maintenance, etc. If you have any questions or needs, please feel free to contact our customer service team, we will serve you wholeheartedly.