Tiếng Việt 
English 
العربية 
Français 
Русский 
简体中文 
Español de Venezuela 
Español 
Tagalog 
**The “Operation Process” in the Safety Operating Regulations for Electric Plate Rolling Machines**
1、 Preparation work
1. Wear protective equipment such as work clothes, safety helmets, and gloves to ensure personal safety.
2. Clean the work area, ensure that there are no debris or obstacles, and ensure that the operating space is unobstructed.
3. Prepare the necessary rolling materials, tools, and measuring tools.
2、 Equipment inspection
1. Conduct a comprehensive inspection of the electric rolling machine, including the motor, transmission system, hydraulic system, electrical control system, etc., to ensure that the equipment is in good condition.
2. Check the lubrication of the equipment, and if necessary, add or replace lubricating oil in a timely manner.
3. Check whether the fasteners of the equipment are tight, and if there is any looseness, tighten them in a timely manner.
3、 Set parameters
1. Reasonably set the parameters of the electric rolling machine, such as the rolling radius, pressing amount, and speed, based on the specifications, materials, and process requirements of the rolling material.
2. Adjust the limit switch of the equipment to ensure that it can automatically stop when it reaches the preset position.
4、 Material placement
1. Place the roll material on the feeding table of the equipment, ensuring that the material is placed smoothly and centered.
2. Adjust the positioning device on the feeding table according to the material specifications, so that the material can accurately enter the rolling machine.
5、 Start operation
1. After ensuring that there are no personnel or obstacles around the equipment, start the electric plate rolling machine.
2. Slowly adjust the equipment speed, observe the operation of the equipment, and ensure that it runs smoothly and without any abnormal noise.
6、 Monitoring process
1. During the rolling process, closely monitor the operating status of the equipment. If there are any abnormalities, stop the machine immediately for inspection.
2. Observe the deformation of the roll material, adjust the pressing amount or speed of the equipment in a timely manner to ensure the quality of the roll.
3. Regularly check the temperature of the equipment. If it is too high, it should be stopped for cooling in a timely manner.
7、 End operation
1. Stop the equipment when the roll reaches the preset length or quality requirements.
2. Remove the rolled material from the equipment and place it in the designated position.
3. Clean the equipment and work area to ensure that the equipment is in standby mode.
8、 Maintenance and upkeep
1. Regularly clean the electric rolling machine to remove impurities such as oil stains and rust.
2. Regularly inspect the lubrication system of the equipment and replace or supplement the lubricating oil.
3. Regularly inspect the electrical control system of the equipment to ensure its safety and reliability.
4. Regularly inspect and maintain the equipment to extend its service life.
The above is the sequence of operation procedures in the safety operation regulations for electric rolling machines. Operators should strictly follow the regulations to ensure the safe and stable operation of the equipment.
