Русский 
English 
العربية 
Français 
简体中文 
Tiếng Việt 
Español de Venezuela 
Español 
Tagalog Adjusting the bending angle of the twist axis CNC bending machine can be done through the following steps:
1. * * Check the debugging status of the machine: First, ensure that the machine is in a good debugging state. Check the spectral size of the X, Y1, and Y2 axes and minimize the problem by adjusting the parameters.
2. * * Spindle angle adjustment * *:
** * Replace fixture tool block * *: If it is necessary to adjust the angle of the spindle, it can be achieved by replacing the fixture tool block. Remove the old fixture and replace it with a new fixture block with the desired angle, then re clamp the fixture.
** * Replace bending mold * *: Select the appropriate bending mold according to the required bending angle and direction, and install it on the machine.
3. * * Mold angle adjustment * *:
** * Loosen fixing screws * *: First, loosen the fixing screws on the upper and lower parts of the bending mold.
** * Adjust mold position * *: Use adjustment tools to move the mold horizontally or vertically until the desired bending angle is achieved.
** * Fixed and inspected * *: Tighten the fixing screws to ensure the stable position of the mold. Afterwards, check if the angle is correct and make further adjustments if necessary.
4. * * Trial processing * *: After adjustment is completed, proceed with trial processing. This not only ensures that the machine can work properly, but also checks whether the processing effect meets the requirements.
Please note that during the adjustment process, special attention should be paid to the hardness and elastic modulus of the material to ensure that the bending meets expectations. In addition, it is recommended to refer to the machine’s user manual or operating manual during the adjustment process to ensure safe and accurate adjustment.
In summary, adjusting the bending angle of the torsion axis CNC bending machine involves multiple steps, including machine inspection, replacement and adjustment of the spindle and mold, as well as trial billet processing. By gradually and meticulously adjusting, the machine can ensure accurate bending operations.
