Manhart CNC Machine Tool CNC Hoop Bending Machine Operation Instructions

1、 Equipment Introduction

CNC bending hoop machine is an efficient and accurate steel bar processing equipment, mainly used for bending and forming steel bars. This equipment adopts advanced CNC technology, which has the characteristics of high automation, high processing accuracy, and high production efficiency.

2、 Equipment installation

When installing the CNC bending machine, it is necessary to follow the requirements of the manual. This includes determining the installation position of the equipment, adjusting the levelness of the equipment, connecting power and air sources, etc. Ensure that the equipment is installed securely without any shaking or tilting.

3、 Preparation before operation

Before operating the CNC bending machine, the following preparations need to be made:

1. Check whether the power and air sources of the equipment are normal;
2. Check whether the transmission part of the equipment is normal, such as whether the lubrication is good;
3. Prepare the steel bars that need to be processed and ensure that the quality of the steel bars meets the requirements;
4. Select appropriate molds and bending procedures based on the material, diameter, and bending requirements of the steel bars.

4、 Operation steps

The operation steps of the CNC bending machine are as follows:

1. Place the reinforcement in the clamp of the feeding mechanism, adjust the position of the clamp, and ensure that the reinforcement is firmly fixed;
2. Open the CNC system, select the appropriate bending program, and input relevant parameters such as steel bar diameter, bending angle, etc;
3. Press the start button to start the equipment processing. During the processing, it is necessary to constantly observe the operating status of the equipment. If there are any abnormal situations, the machine should be stopped for inspection in a timely manner;
4. After processing, close the CNC system, take out the finished steel bars, and conduct quality inspection.

5、 Precautions

When using a CNC bending machine, the following points should be noted:

1. Strictly follow the operating procedures to avoid safety accidents;
2. During the processing, it is important to constantly monitor the operating status of the equipment to avoid any abnormal situations;
3. Regular maintenance and upkeep of equipment to ensure its normal use and lifespan;

For beginners, it is recommended to operate under the guidance of professionals.

6、 Maintenance and upkeep

In order to maintain the good performance and service life of the CNC bending machine, regular maintenance and upkeep are required. Including the following points:

1. Regularly inspect the transmission parts of the equipment, such as bearings, chains, etc., to ensure their normal operation;
2. Regularly clean the oil and dust on the equipment to maintain its cleanliness;
3. Check the lubrication of the equipment and regularly add lubricating oil or grease;
4. Regularly inspect the electrical part of the equipment to ensure its normal operation.

7、 Common faults and troubleshooting

During the use of CNC bending machines, some common malfunctions may occur. Here are some common faults and troubleshooting methods:

1. The device cannot start: Check if the power and air sources are normal; Check if the electrical connections of the equipment are good.
2. Reinforcement clamping is not firm: adjust the position of the fixture or replace the fixture; Check if the quality of the steel bars meets the requirements.
3. The bending accuracy does not meet the requirements: check whether the parameter settings of the equipment are correct; Check if the mechanical parts of the equipment are functioning properly.
4. Abnormal sound or vibration of the equipment: Check whether the transmission part of the equipment is normal; Check the lubrication of the equipment.
5. Electrical failure of equipment: Check whether the electrical part of the equipment is normal; Contact professional electrical maintenance personnel for inspection and repair.

8、 Technical support and after-sales service

If you encounter any problems or malfunctions while using the CNC bending machine, you can contact our technical support and after-sales service team. We will provide you with professional technical support and solutions. In addition, we will also provide regular inspections and maintenance services for your equipment to ensure that it always maintains good performance and service life.