Manhart Safe operation of oil electric servo pump controlled bending machine

**Safety operation guide for oil electric servo pump controlled bending machine**
1、 Introducción
As an important equipment in modern sheet metal processing, the oil electric servo pump controlled bending machine’s safe operation is of great significance for ensuring personnel safety and improving production efficiency. This guide will provide a detailed introduction to the safety operation specifications of oil electric servo pump controlled bending machines, including wearing personal protective equipment, checking equipment status, preparing operating components, checking mold overlap, adjusting positioning devices, handling abnormal sounds, and coordinating work.
2、 Wear personal protective equipment
1. Operators must wear complete labor protection equipment, including safety helmets, protective goggles, earplugs, protective gloves, work clothes, etc.
2. Ensure that labor protection equipment meets safety standards, is free from damage or stains, and is worn correctly.
3、 Check device status
1. Before starting up, conduct a comprehensive inspection of the equipment to ensure that all components are intact, free of looseness, and without abnormalities.
2. Check the hydraulic oil level, electrical circuits, lubrication system, etc. to ensure that the equipment is in good working condition.
4、 Preparation of operating components
1. Confirm that the power switch is in the off state to avoid accidental startup.
2. Clean up the debris on the workbench and ensure that the work area is clean.
3. Prepare the required molds, tools, etc. and place them in the designated location.
5、 Mold overlap inspection
Before installing the mold, check the integrity and accuracy of the mold to ensure that there are no defects such as cracks or deformations.
2. After installing the mold, use special tools to check the overlap of the mold, ensuring that the upper and lower molds are completely aligned, and avoiding deviations during the bending process.
6、 Positioning device adjustment
According to the requirements of the workpiece, adjust the position and angle of the positioning device to ensure that the workpiece can be accurately and stably placed on the bending machine.
2. Check if the positioning device is firm and reliable to avoid movement or deformation during the bending process.
7、 Abnormal sound processing
During the bending process, if abnormal sounds or equipment vibrations are heard, the machine should be stopped immediately for inspection.
2. After identifying the cause of the abnormality, take corresponding measures, such as replacing worn parts, adjusting parameters, etc.
3. Do not continue operating the equipment until the cause is identified or the fault is resolved.
8、 Cooperate with work coordination
When multiple people operate or cooperate in work, their respective responsibilities and tasks should be clearly defined to ensure the orderly progress of the work.
During the operation process, mutual communication and coordination should be maintained to avoid misoperation or collision accidents.
In case of emergency, the machine should be immediately shut down and corresponding emergency measures should be taken to ensure the safety of personnel and equipment.
9、 Conclusion
The safe operation of the oil electric servo pump controlled bending machine is an important prerequisite for ensuring smooth production and personnel safety. Operators should strictly comply with the regulations and requirements in this guide to ensure the safe and stable operation of the equipment. At the same time, enterprises should also strengthen equipment management and maintenance work, improve the service life and performance stability of equipment.