Manhart How to determine the pressure parameters of the twisting axis bending machine through trial processing?

To determine the pressure parameters of the twisting axis bending machine through trial processing, the following steps can be followed to ensure the quality and efficiency of the bending process:
### 1. Initial settings
** * Refer to the manual * *: Firstly, consult the operation manual of the twisting axis bending machine to understand the basic parameters, performance characteristics, and recommended initial pressure setting range of the equipment.
*Set initial pressure: Based on the manual and the characteristics of the raw materials (such as thickness, hardness, etc.), set an initial pressure parameter within the allowable range of the equipment.
### 2. Preparation for trial processing
** * Material Preparation * *: Prepare sufficient quantities and types of raw materials for trial processing.
*Mold selection: Select the appropriate mold based on the thickness and hardness of the material, and install and fix it.
*Adjusting the worktable: Adjust the height and angle of the worktable to meet the requirements of the trial machined workpiece.
### 3. Trial processing process
*Gradually increasing pressure: Starting from the initial pressure parameter, gradually increase the pressure value in small increments, and conduct trial processing after each increase.
** * Observing bending effect * *: Carefully observe the workpiece after each trial processing, evaluate the bending angle, flatness, and whether there are quality issues such as cracks or deformations.
** * Record data * *: Record the pressure value, bending effect, and any other observed phenomena for each trial processing.
### 4. Analysis and Adjustment
*Data analysis: Analyze the trial processing data to identify the optimal pressure range for bending effect.
** * Fine tuning pressure * *: After finding the optimal pressure range, fine tune until the desired bending effect is achieved.
*Attention: During the adjustment process, special attention should be paid to preventing material breakage or equipment overload caused by excessive pressure, as well as avoiding insufficient deformation of the material caused by insufficient pressure.
### 5. Verification and determination
** * Re processing * *: Use the adjusted pressure parameters for re processing to verify whether the bending effect is stable and reliable.
** * Determine Parameters * *: If the verification results meet the requirements, the pressure parameter can be determined as the final processing parameter.
###Induction and Precautions
*During the trial processing, it is necessary to strictly follow the operating procedures and safety regulations to ensure the safety of personnel and equipment.
*For different types of materials and workpieces, different pressure parameter settings may be required, so multiple trial machining and adjustments are needed.
*Determining pressure parameters through trial processing is an iterative process that requires patience and meticulous operation to ensure the desired bending effect is achieved.
By following the above steps and precautions, it is possible to effectively determine the pressure parameters of the twisting axis bending machine through trial processing, thereby ensuring the quality and efficiency of the bending process.