Manhart How to maintain the full electric servo bending machine on a daily basis?

The daily maintenance of the fully electric servo bending machine is crucial for ensuring stable equipment operation, extending service life, and reducing safety accidents. The following are the daily maintenance steps and precautions for a fully electric servo bending machine based on the provided reference articles:
1. Daily cleaning:
-Regularly clean the casing and internal wiring of the equipment, especially the radiator and fan parts.
-Use compressed air or a soft brush to gently remove dust and debris, ensuring good ventilation.
-Avoid using water or cleaning agents to avoid damaging the motor or electronic components.
2. * * Lubrication * *:
-According to the manufacturer’s recommendations, regularly check and replace the lubricating oil or grease of the servo motor.
-Choose the appropriate lubricant and follow the correct lubrication procedure.
-Regularly lubricate and lubricate the guide rods, molds, tool holders, and other parts of the equipment to reduce wear and tear.
3. * * Check and tighten * *:
-Regularly inspect the connectors, wiring terminals, screws, and other parts of the servo motor to ensure that they are firmly connected and not loose.
-For loose or worn components, they should be tightened or replaced in a timely manner.
-Regularly inspect the electrical connections of the equipment to ensure good contact and no open or short circuits.
4. * * Temperature Management * *:
-Regularly check the temperature of the servo motor to ensure it operates within the normal range.
-If the motor is found to be overheated, timely measures should be taken to cool down, such as adding heat dissipation devices and improving ventilation conditions.
5. * * Troubleshooting * *:
-Regularly check the operation status of the equipment, including noise, vibration, etc. If there are abnormalities, timely troubleshooting and maintenance should be carried out.
-For equipment malfunctions, the cause should be promptly identified and repaired or replaced according to the manufacturer’s recommendations.
6. * * Daily Inspection * *:
-Conduct daily inspections to ensure that the equipment operates normally and there are no overloads or abnormal phenomena.
-Pay special attention to the lubrication system, electrical connections, and other critical parts of the equipment to ensure they are in good condition.
7. * * Environmental maintenance * *:
-Place the equipment in a dry and clean environment to avoid moisture and dust that may affect its normal operation.
-Try to avoid using the equipment in direct sunlight or enclosed environments to ensure good heat dissipation conditions.
8. Regular replacement:
-For vulnerable parts and consumables of equipment, such as wires, batteries, hydraulic oil, etc., they should be replaced regularly to ensure the normal operation of the equipment.
-Follow the manufacturer’s recommendations for replacement work and use accessories and materials purchased through legitimate channels.
In summary, the daily maintenance of the fully electric servo bending machine requires attention to cleaning, lubrication, inspection and fastening, temperature management, troubleshooting, daily inspections, environmental maintenance, and regular replacement. Through meticulous maintenance and upkeep, the stable operation and extended service life of the equipment can be ensured.