English 
العربية 
Français 
Русский 
简体中文 
Tiếng Việt 
Español de Venezuela 
Español 
Tagalog When the temperature of the rolling machine is too high during operation, the following measures can be taken to solve the problem:
1. * * Check hydraulic motor * *: First, check if the oil temperature of the hydraulic motor is too high. If the oil temperature rises, it may be due to leakage at the hydraulic pump and its connections, resulting in volume loss and heating. At this point, all connections should be tightened to enhance sealing, in order to reduce energy loss and heat generation.
2. * * Adjusting the fuel tank and cooling system * *: If the volume of the fuel tank is too small or the heat dissipation conditions are poor, it can be considered to increase the volume of the fuel tank appropriately, and if necessary, set up a cooler. Meanwhile, choose hydraulic oil with lower viscosity to reduce internal friction and heat generation.
3. * * Optimize oil pipe layout * *: Check if the oil pipe is too slender and bent, which may cause an increase in oil flow resistance and oil temperature. If this situation exists, it can be considered to increase the pipe diameter and shorten the pipeline to improve the oil flow condition.
4. * * Improve environmental temperature * *: If the ambient temperature is too high, insulation materials and reflective plates can be used to isolate the equipment from the external environment and reduce oil temperature.
5. * * Regular Inspection and Maintenance * *: Regularly maintain the rolling machine, clean dust and dirt, and check the operation of the hydraulic and electrical systems. Keeping the equipment clean and in good operating condition helps to reduce temperature.
If the above measures still cannot solve the problem, it may be necessary to further inspect other components of the rounding machine, such as bearings, gears, etc., for faults or poor operation. During the operation, it is essential to pay attention to safety, follow the equipment operating procedures, and avoid accidents. If the problem is serious or cannot be solved on its own, it is recommended to contact professional technical personnel or equipment manufacturers for repair and debugging in a timely manner.
