العربية 
English 
Français 
Русский 
简体中文 
Tiếng Việt 
Español de Venezuela 
Español 
Tagalog **Set appropriate welding and cutting parameters through the control panel**
The control panel is the core part of laser welding and cutting machines, through which various parameters can be adjusted and set to achieve the best processing effect. The following are detailed steps on how to set appropriate welding and cutting parameters through the control panel:
###1、 Welding parameter settings
1. * * Laser power adjustment * *:
*Choose the appropriate laser power based on the thickness and type of material. Thicker materials require higher power, while thinner materials can choose lower power.
*Gradually increase or decrease the laser power and observe the welding effect until the desired weld quality and appearance are achieved.
2. * * Welding speed adjustment * *:
*The welding speed determines the efficiency and quality of the welding process. Faster speeds may lead to incomplete fusion of welds, while slower speeds may result in excessive heat input and workpiece deformation.
*Gradually adjust the welding speed based on the thickness and type of material, as well as the required weld quality.
3. * * Focus position adjustment * *:
*The focus position determines the way the laser beam interacts with the workpiece. When the focus is above the surface of the workpiece, it is suitable for thicker materials; When the focus is located inside the workpiece, it is suitable for thinner materials.
*By adjusting the focus position through the control panel, observe the welding effect to obtain the best weld quality and appearance.
###2、 Cutting parameter settings
1. * * Laser power adjustment * *:
*The laser power required for cutting is usually higher than that for welding. Choose the appropriate laser power based on the thickness and type of material.
*Gradually increase or decrease the laser power, observe the cutting effect, and achieve the desired cutting quality and speed.
2. * * Cutting speed adjustment * *:
*The cutting speed determines the efficiency and quality of the cutting process. Too fast a speed may lead to incomplete cutting, while too slow a speed may result in excessive heat input and workpiece deformation.
*Gradually adjust the cutting speed based on the thickness and type of material, as well as the required cutting quality.
3. * * Auxiliary gas adjustment * *:
*For certain materials, such as stainless steel, the use of auxiliary gases (such as oxygen or nitrogen) can improve cutting quality and speed.
*Adjust the flow rate and pressure of auxiliary gas through the control panel to achieve the best cutting effect.
###Precautions
*When adjusting parameters, it is recommended to start from a small range, gradually adjust, and observe the welding or cutting effect.
*After each parameter adjustment, it is necessary to wait for the device to stabilize before proceeding to the next adjustment.
*Different materials and thicknesses may require different parameter combinations, so continuous experimentation and optimization are necessary in practical operations.
*When setting parameters, it is also necessary to consider the performance and limitations of the device to avoid exceeding its capacity.
In summary, setting appropriate welding and cutting parameters through the control panel is a process that requires continuous experimentation and optimization. Only by continuously accumulating experience in practical operations can we find the most suitable parameter combination for the current workpiece and equipment.