English 
العربية 
Français 
Русский 
简体中文 
Tiếng Việt 
Español de Venezuela 
Español 
Tagalog When cleaning the circuit system of a CNC punching machine, determining the amount of cleaning agent and temperature are two key factors. Here are some guiding principles to help you make the right choice:
**Cleaning agent dosage * *:
1. * * Refer to the instructions * *: First, check the instructions for the cleaning agent. The manufacturer usually provides a recommended dosage range. Choose an appropriate amount of cleaning agent based on the size and degree of contamination of the circuit board.
2. * * Avoid waste and excess * *: While ensuring cleaning effectiveness, try to reduce the amount of cleaning agent used to avoid waste. At the same time, it is also important to avoid using too much cleaning agent to prevent residual cleaning agents from potentially affecting the circuit.
3. * * Uniform application * *: When using cleaning agents, ensure that they are evenly applied on the surface of the circuit board to thoroughly clean all parts.
**Cleaning agent temperature * *:
1. Room temperature operation: Generally speaking, most electronic cleaning agents have the best effect when used at room temperature. Unless otherwise specified, it is not recommended to heat or use excessively cold cleaning agents.
2. * * Avoid extreme temperatures * *: High temperatures may cause cleaning agents to evaporate too quickly, affecting cleaning effectiveness, and may even cause thermal damage to certain components on the circuit board. Low temperatures may lead to poor fluidity of cleaning agents, making it difficult to evenly apply them to circuit boards.
3. * * Adjust according to the type of cleaning agent: Some special types of cleaning agents may have specific temperature requirements. Before use, be sure to check the instructions of the cleaning agent to understand its temperature requirements.
Please note that different brands and types of cleaning agents may have different dosage and temperature requirements. Therefore, when choosing cleaning agents, it is best to carefully read the product manual and make adjustments according to the actual situation. If you have any questions or uncertainties about the use of cleaning agents, it is recommended to consult professional personnel or manufacturer technical support.
In addition, in addition to the amount and temperature of cleaning agents, attention should also be paid to operating methods and safety precautions during the cleaning process, such as ensuring that the equipment is powered off, wearing protective equipment, and avoiding the use of water or other unsuitable liquids. Only by performing cleaning operations correctly and safely can the circuit system of the CNC punching machine be effectively protected, ensuring its normal operation and extending its service life.
